3.1~5.2 GHz

龙源期刊网 www.1mpi.com

3.1~5.2 GHz超宽带可变增益低噪声放大器设计

作者:黄健男张科峰刘览琦

来源:《现代电子技术》2012年第04期

摘要:低噪声放大器是超宽带接收机系统中最重要的模块之一,设计了一种可应用于

3.1~5.2 GHz频段超宽带可变增益低噪声放大器。电路输入级采用共栅结构实现超宽带输入匹配,并引入电流舵结构实现了放大器的可变增益。仿真基于TSMC 0.18 μm RF CMOS工艺。结果表明,在全频段电路的最大功率增益为10.5 dB,增益平坦度小于0.5 dB,噪声系数小于5 dB,输入反射系数低于-15 dB,在1.8 V电源电压下,功耗为9 mW。因此,该电路能够在低功耗超宽带射频接收机系统中应用。

关键词:超宽带;可变增益;低噪声放大器;电流舵;低功耗

中图分类号:文献标识码:A文章编号:

Design of variable gain low noise amplifier working in 3.1~5.2 GHz ultra wideband

3.1~5.2 GHz

(Huazhong University of Science and Technology, Wuhan 430074, China)

Abstract: Low noise amplifier is the most important part in ultra wideband (UWB) receiver system. A variable gain low noise amplifier (LNA) wiorking in 3.1~5.2 GHz UWB was designed. A

3.1~5.2 GHz

simulation is carried out based on TSMC 0.18μm RF CMOS process. The results of the simulation show that the low noise amplifier′s maximum power gain is 10.5 dB, ripple is less than 0.5 dB in the designed band, input return loss is less than ―15 dB, noise figure is below 5 dB, and power dissipation is 9 mW

3.1~5.2 GHz

Keywords:

3.1~5.2 GHz

consumption

收稿日期:

基金项目:国家科技重大专项课题()0引言

超宽带(UWB)无线通信技术因具有低功耗,高传输速率以及抗干扰能力强等优点,近年来在WPAN、无线USB等高速无线通信领域,以及无线传感器网络、可植入式医疗器具等

3.1~5.2 GHz的相关文档搜索

3.1~5.2 GHz相关文档

最新文档

返回顶部